Epson TM-290-II Operator's Manual page 32

ESC 2
Set 1/6 inch line spacing
N a m e
< 1 B >
F o r m a t
Description Sets the line spacing to 1/6 of an inch.
N o t e s • The set values for Standard and Page Modes are inde-
pendent, and they are valid only in the corresponding mode.
n
ESC 3
N a m e
Set line spacing using minimum units
F o r m a t < 1 B >
R a n g e
Sets the line spacing to n/60 inches.
Description
• The set values for Standard and Page Modes are
N o t e s
n = 10 (1/6 inch)
D e f a u l t
ESC @
N a m e
Initialize printer
< 1 B >
F o r m a t
Description Clears the data in the print buffer and resets the printer
mode (the same state as when the power is turned on).
• The DIP switches are not read again.
N o t e s
• The data in the receive buffer is not cleared.
n
ESC C
N a m e
Set cut sheet eject length
< 1 B >
F o r m a t
R e n g e
Description Set the eject length for cut sheets to n lines.
• When n = 0, no eject length will be set.
N o t e s • If the line spacing is changed after the eject length is set,
• The eject length set by this command is used only when
< 32 >
H H
< n >
< 3 3 >
H H
independent, and they are valid only in the corresponding
mode.
< 40 >
H H
< n >
< 4 3 >
H H
the eject length remains unchanged.
FF
(Form Feed) is executed.
- 2 7 -