Rcom MARU DELUXE Hatcher & Brooder MX-100HBD User Manual page 11

Humidity and Condensation principles, Air Flow considerations
▶ When hatching, humidity should be relatively high to prevent the thin membrane from drying out or hardening
before hatching.
▶ When hatching, it's recommended not to open the door often.This is because if you open the door often humidity
will be rapidly decreased and it will take a long time to regain the proper humidity.
machine internal temperature is 37
in that case, RH 70% humidity is may not be able. The difference of ±5% humidity value may occur
from the humidity sensors difference, and there are no problems at hatching.
▶ It's very important to maintain humidity higher 1~2 days before hatching than the early and middle incubation
periods. Humidity requirements during incubation are RH 45~55% for waterfowl, RH 40~45% for poultry and
RH 35~45% for parrot, in general. One day before hatching, all kinds of birds need about RH 65% humidity
and sometimes need higher than that. However, in areas of high ambient humidity, lower levels of humidity may
be needed during incubation.
▶ Air Controlling Lever : Outer fresh air can be flowed into machine inside without affecting insulation. When eggs
start hatching, open air controlling lever either fully or half-open.
▶ If the temperature where machine installed is high, it will effects to tmachine setting temperature.
In this case, you are able to adjust temperature by Air ventilation on the top of machine.
You can adjust
Air Ventilation
1/4 open
If you set high temperature, condensation will occur the near Air Vent and may causes licking water from the
machine and it is not a technical problem.
DIGITAL INCUBATOR
3. Hatcing and Brooding
℃ ℉
(98.6 ) or more, and hatching room temperature is below 28
1/2 open close
(3) Humidity and Condensation principles,
Air Flow considerations, and Post-Hatch maintenance,
Dew Condensation
wide open
℃
,
11