C3850-Nm-8-10G Module; C3850-Nm-2-40G Module - Cisco Catalyst 9300 Series Hardware Installation Manual

C3850-NM-8-10G Module

Interface
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
C3850-NM-8-10G Module
All ports in the C3850-NM-8-10G module default to 10 G and should be configured as TenGigabitEthernet1/1/1
through TenGigabitEthernet1/1/8, even when you are operating them as 1 G using SFP.
Table 27: C3850-NM-8-10G Module
Interface
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
TenGigabitEthernet1/1/5
TenGigabitEthernet1/1/6
TenGigabitEthernet1/1/7
TenGigabitEthernet1/1/8

C3850-NM-2-40G Module

The default port connections for the C3850-NM-2-40G module depends on whether you use a 40 G QSFP
module or a 4x10G breakout cable.
If you use a 40 G QSFP module, the ports default to 40 G interfaces. In this case, the 10 G interfaces are
displayed but not used.
Table 28: C3850-NM-2-40G Module with 40 G QSFP Module
Interface
FortyGigabitEthernet1/1/1
FortyGigabitEthernet1/1/2
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
58
Action
Disregard
Configure this interface, even when operating as 1-G
Configure this interface, even when operating as 1-G
Action
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Action
Configure this interface
Configure this interface
Disregard
Disregard
Disregard
Disregard
Installing a Network Module