Cisco Catalyst 9300 Series Hardware Installation Manual page 106

Configuring Your Device Based on a Site Profile
Setting
SSH
SCP
VTY Access to Switch
Service Timestamp
VLAN
Management Interface
IPv6 Host Policy
QoS Policy for Downlink
Ports
QoS Policy for Uplink
Ports
Uplink Interfaces
Downlink Interfaces
Port-channel
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
94
Single Access Switch Single Access Switch
(Single Uplink) (Single Port Channel
Uplink)
Version 2 Version 2
Enabled Enabled
Enabled Enabled
Enabled Enabled
The following VLANs are The following VLANs are
created: created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
Layer 3 settings Layer 3 settings
configured on the configured on the
management port, based management port, based
on Quick Setup on Quick Setup
IPv6 host policy created IPv6 host policy created
Auto QoS Policy for Auto QoS Policy for
Access defined Access defined
QoS Policy for QoS Policy for
Distribution created Distribution created
Selected uplink interfaces Selected ports configured
configured as trunk ports, as Port-channel in trunk
set to allow all VLANs mode, set to allow all
VLANs.
Downlink ports Downlink ports
configured in Access configured in Access
mode mode
Not configured Port-channel to
distribution created
Single Access Switch
(Redundant Port Channel
Uplink)
Version 2
Enabled
Enabled
Enabled
The following VLANs are
created:
• Default VLAN • Default VLAN
• Data VLAN • Data VLAN
• Voice VLAN • Voice VLAN
• Management VLAN • Management VLAN
Layer 3 settings
configured on the
management port, based
on Quick Setup
IPv6 host policy created
Auto QoS Policy for
Access defined
QoS Policy for
Distribution created
Selected ports configured
as Port-channel in trunk
mode, set to allow all
VLANs.
Downlink ports
configured in Access
mode
Port-channel to
distribution created
Configuring the Switch