Advertisement
How to install your
Vertical Honeycomb Blind
Need HELP?
Call our
Customer Service team
for assistance
1300 836 382
Feedback?
We would love to know how you
went with your installation...
Please write a review on our
website at...
www.venetablinds.com.au
1
Installation Brackets
Installing inside the window frame...
At top of window or door frame, measure 80mm
in from each end and mark with a pencil. This is
the edge of the outer brackets.
Place brackets in position flush with the front
of the window opening and mark where the
screws will go.
We recommend drilling pilot holes for the
screws using a 2mm bit.
Fix the brackets into position using 2 long screws for each bracket.
If more brackets are supplied, space them evenly between the first two brackets.
Installing outside the window frame...
Measure 80mm in from top left and top right of where blind will sit (normally edge of
architrave) and mark with a pencil. This is the edge of the outer brackets.
Position the top of bracket 3mm above the architrave and mark where the screws will go.
We recommend using a spirit level to align brackets if not installing on the architrave.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the brackets into position using 2 long screws for each bracket.
If more brackets are supplied, space them evenly between the first two brackets.
2
Head Rail
Position the top lip of the headrail under
the top front lip of the brackets as per
diagram to the right.
Push the headrail up at the back to click
into position as per diagram to the right.
3
Clips & Rollers
Attach clips to rollers (clips are attached to top of fabric).
4
Fixed Vertical Rail
Note: Do not untie the cords at the top of the
vertical rail.
Position the vertical rail up into the slots at the
back of headrail as per photo.
Lock the vertical rail into place by screwing the
bolt until firm (note the screw does not screw
into anything and will still be loose).
80mm
Head rail
Side view
80mm
Installation bracket
2
Advertisement
