Download Print this page

VENETA Smartfit Day & Night Honeycomb Quick Start Manual

Advertisement

Quick Links

How to install your
Smartfit Day & Night Honeycomb Blind
#65101-11520-A
Required Tools
Included Hardware
The hardware can be found in
the end of every box.
Shoe Base
(For Headrail and
Bottom Rail)
Shoe Slider
(Attached to blind)
Installation
L Bracket
(Outside Install)
L Bracket Cover
(Outside Install)
Handle
Short Bolt
Long Screws for
Wood
Wall Plugs for Brick
or Cement using
a 6mm bit
(if requested)
Extension Pole
(if requested)
measuring
drill with
tape
2mm bit
1
Installation Brackets
Installing inside the window frame...
At top and bottom of window frame measure at least 12mm in
from each end and 14mm back from front of window frame and
mark where the screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the Shoe Bases into position using 1 long screw for each Shoe
ensuring the outer edge is to the outside of the window.
Inner Edge
Installing outside the window frame...
We recommend using a spirit level for vertical and horizontal
alignment.
Place the blind in position and mark the top corners of the blind.
Measure 4mm down and 5mm in from the top left and top right of
where the blind will sit, and mark the location of the L bracket outer
screws (ensure screws are at least 16mm from window opening).
The measurement from this screw to the screw on the bottom brackets
is the 'order height' minus 8mm (order height can be found on the
outside of your box). And mark with a pencil.
Place L brackets in position and mark where the other screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the L brackets into position using 2 long screws for each bracket.
Fix the Shoe Bases onto the L Brackets using 1 short bolt for each shoe,
ensuring the outer edge is to the outside of the window.
2
Attach Handle
Attach the handle to the handle support pre-attached on the rail then slide against the handle
support to the left until the handle can't move anymore.
(25mm Cell)
phillips bit or
screwdriver
Outer Edge
2
1
★★☆ ☆ ☆
Difficulty:
pencil
knife
3
1

Advertisement

loading

Summary of Contents for VENETA Smartfit Day & Night Honeycomb

  • Page 1 How to install your Smartfit Day & Night Honeycomb Blind (25mm Cell) #65101-11520-A ★★☆ ☆ ☆ Difficulty: measuring drill with phillips bit or pencil knife Required Tools tape 2mm bit screwdriver Included Hardware Installation Brackets Installing inside the window frame… At top and bottom of window frame measure at least 12mm in The hardware can be found in from each end and 14mm back from front of window frame and...
  • Page 2 Place Shoe Sliders into centre of Shoe Bases and slide towards the outer edge of Shoe as per diagram below. Great Job… Enjoy your new Veneta Blinds! Lower and raise the blind using the handles on the top, middle and bottom rails.