VENETA Zebra Blind Quick Start Manual

How to install your
Motorised Zebra Blind

Required Tools

Included Hardware

The hardware can be found in
the small plastic bag included
with your blind.
Installation Bracket
(inside window frame)
Installation Bracket
(outside window frame)
Remote Control
Screws for Wood,
Metal or Wall
Anchors
Wall Anchors for
Brick or Cement
Feedback?
Please write a review on our
website letting us know your
experience with Veneta Blinds
www.venetablinds.com.au
measuring drill with
tape 2mm bit
1

Installation Brackets

Installing inside the window frame...
▪ At top of window frame, measure 90mm in from each end and 40mm back from the front of
the window frame, and mark the screw position for the small round hole on bracket.
▪ Place brackets in position and mark where the other screws will go.
▪ We recommend drilling pilot holes for the screws using a 2mm bit.
▪ Fix the brackets into position using 2 screws for each bracket.
▪ If more brackets are supplied, space them evenly between the first two brackets.
Installing outside the window frame...
▪ Measure 90mm in from top left and top right of where the blind will sit (normally edge of
architrave) and mark the position of the centre of the brackets.
▪ Place brackets in position and mark where the other screws will go.
▪ We recommend using a spirit level to align brackets if not installing on the architrave.
▪ We recommend drilling pilot holes for the screws using a 2mm bit.
▪ Fix the brackets into position using 2 screws for each bracket.
▪ If more brackets are supplied, space them evenly between the first two brackets.

Install Blind

2
▪ Note the position of the bracket in the
photo to the right...
▪ Position the second lip on top of the
headrail into the front lip of bracket.
▪ Tilt the back of the blind up and apply
firm pressure at the back of the blind, to
click the blind into place.
phillips bit or pencil
screwdriver
knife