VENETA Skylight Honeycomb Blind Manual

How to install your
Skylight Honeycomb Blind
#65101-10239-C
Required Tools
Included Hardware
The hardware can be found in
the end of every box.
Installation Bracket
(Top Rail)
Installation Bracket
(Bottom Rail)
L Bracket
(Bottom Rail)
(Outside Mount
Only)
L Bracket Cover
Long Screws
for Wood
Bolt
Handle
Regulator
Wall Plugs for Brick
or Cement using
a 6mm bit
(if requested)
Extension Pole
(if requested)
measuring drill with
tape 2mm bit
1
Installing INSIDE the window frame
Top and Bottom Rail Brackets:
At top of window opening, measure 50mm in
from each end and 16mm back from the front
of the window opening and mark with a
pencil; this is the position of the screw for the
outer brackets.
At bottom of window opening, measure 25mm
in from each side and 12mm back from the
front of the window opening and mark with a
pencil; this is the position of the screw for the
outer brackets.
We recommend drilling pilot holes for the
screws using a 2mm bit.
Fix the brackets into position using the long
screws provided.
If more brackets are supplied, space them
evenly between the first two brackets.
Install Blind:
Place the top front of the blind under the top front lip
of the brackets.
Push the blind up at the back to click into position.
Extend the blind and place the bottom front of
the blind under the front lip of the bottom brackets.
Push the blind down at the back to click into position.
Ensure the blind has clicked firmly into place.
Note: Ensure screw is in the centre of the bottom bracket.
2
Installing OUTSIDE the window frame
Top Rail Brackets:
Place the top of the blind in position, mark the top corners with a pencil.
Measure 50mm in from each mark; this is the position of the top centre of the brackets.
Place brackets in position and mark where the screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the brackets into position using the long screws provided.
If more brackets are supplied, space them evenly between the first two brackets.
Install Top Rail:
Place the top front of the blind under the top front lip of the brackets.
Push the blind up at the back to click into position.
Ensure the blind has clicked firmly into place.
Difficulty:
phillips bit or pencil
screwdriver
7.5mm
Top Rail
2
★ ★ ★ ☆☆
knife
Bottom Rail
16mm
1
3
1