Vertical Alignment; Handle; Operating Your Blind; Maintaining Your Blind - VENETA Vertical Honeycomb Blind Manual

How to install, operate and maintain your
Vertical Honeycomb Blind
9

Vertical Alignment

If the movable vertical rail is not vertical, adjust the screw as per photo.
Turn the screw either clockwise or anti-clockwise to make the rail vertical.
Note: the fabric can be crinkled and will bounce back into place.
10

Handle

Slide the handle onto the movable vertical rail.
Operating your
Blind
Maintaining your
Blind
Feedback?
We would love to know how you
went with your installation...
Please write a review on our
website at...
www.venetablinds.com.au
Great Job... Enjoy your new Veneta Blinds!
To operate the blind simply slide the blind using the handle.
1

Removing your blind

Remove the blanket from the head rail.
Hold the blanket, and then to remove the vertical rail from the head rail.
Refer to below guide to remove the head rail.
a. Position a flat head screw driver between the back of the headrail and bracket.
b.Push screw driver upwards
c.Pull back of headrail down to unclip bracket from headrail.
d.Repeat for all other brackets.
2

Dusting

Dust can be removed using a feather duster or vacuum with brush attachment
on low suction.
3

Spot Cleaning

Use a warm damp cloth or a mild detergent for tougher stains.
Dab the affected area, but do not rub the fabric. Finish with just a warm damp cloth.
Allow the fabric to dry in the closed position.
4

Ultrasonic Cleaning

If ultrasonically cleaning the blind please specify that a mild solution must be used.
Note the rails should never be immersed in liquid.
4