Specifications - Blaupunkt SA 2900R User Manual

9.4. Remote Controller
 Remote Controller LED glows dimly when any key is pressed
-- Remote Controller on low battery.
9.5. Factory Reset
The Factory Reset function will delete all learned in devices and returns all system setting to default value. After the setting you will need to setup the
system again from the beginning via
1. Power down Control Panel by disconnecting AC Power and switching off battery switch.
Apply AC Power while holding down the  key.
2.
Release the  key when you hear a beep, the screen will display
3.
Enter the following keys sequence: ,
4.
OK
5. Press the key again.
6. Reset is complete and all programmed parameters are reset to factory default setting.

10. Specifications

10.1. All Devices
Environmental Condition
-10°C to 40°C, relative humidity 85% non-condensing for Control Panel and all devices.
Radio Operation Range
About 30m in typical domestic installation, range can vary depending on building construction, device location, and environment.
10.2. Control Panel
Display
2x16 character LCD
Keypad
17 keys keypad
Siren Output
96 dBA sound pressure @ 1m minimum
Zones
10.3. PIR Sensor
Radio Frequency
868MHz
Battery
1 x 3V lithium battery
10.4. Remote Controller
Radio Frequency
868MHz
Battery
1 x CR2032 3V lithium coin cell
First Time Setup.
Enter Code.
OK
30 radio devices (Plus 4 optional Power Switches).
Power Supply
DC9V 1A Power Adaptor
Battery
4.8V 600mAH Ni-MH Rechargeable Battery, charge time 72 hours.
Battery Backup Time
18 hours
Door Contact
Radio Frequency
868MHz
Battery
1 x 3V CR2 lithium battery
19