Blaupunkt SA 2900R User Manual page 17

2. The Exit Delay timer will begin to count down.
3. When the Exit Delay time is up, the Control Panel will enter the arm mode you selected.
7.4. Disarm
When the system is under Away Arm or Home Arm mode, to disarm the system:

For Control Panel, press the "Disarm"

For Remote Keypad, enter a User PIN Code and press the
 For Remote Controller, press "Disarm"
7.5. Alarm Activation
 When a device set to Burglar is triggered, the alarm will be activated immediately.

When a device set to Entry is triggered, the Entry countdown timer will be activated. If the system is not disarmed before the timer expires, an
alarm will be activated.
 When a device set to Home Omit is triggered in Home Arm mode, the device will be ignored. If the device is triggered in Away Arm mode, the
alarm will be activated immediately
 When the tamper switch of the Control Panel or devices is triggered in Away Arm mode, the alarm will be activated immediately.
 You can trigger an Emergency alarm with the Remote Controller

You can trigger an Emergency/Fire/Medical alarm with the Remote Keypad
7.6. Stopping the Alarm and Alarm Display
During an alarm, the Control Panel will sound the siren, and report to programmed telephone number. The screen will display "ALARM! ALARM!" to notify
the user
Stopping the Alarm
 Enter a User PIN Code and press
 Enter a User PIN Code and press
 Disarm
Press key on the Remote Controller
 The alarm will be stopped; the device that triggered the alarm will be displayed on screen. Use the Down button to scroll down the alarm event,
the screen will display whether the system reported successfully to programmed telephone number or not.

When you finish viewing the alarm event, the system will enter Disarm mode.
NOTE:
1. Remote Controller cannot be used to stop the Emergercy Alarm triggered by itself.
2. If you disarm the system with Remote Controller, the Control Panel screen will continue to display "ALARM!ALARM!" message to remind you
to check the alarm memory.
7.7. Tamper Protection
 When the system is under Away mode, if a tamper switch is triggered, an alarm will be activated immediately. The Control Panel will send a SMS
alarm event "Tamper" to programmed SMS report telephone number, or dial the Voice report telephone number and play "Burglar" message upon
answer.

When the system is under Home or Disarm mode, if a tamper switch is triggered, the Control Panel will not make any report or activate alarm. The
fault LED will light up and a fault event will be registered in the Control Panel.
7.8. Alarm Reporting Sequence
When an alarm is activated, the Control Panel will first make GPRS report, then dial the programmed telephone numbers in priority order for Voice
Message or SMS Message report. When the Control Panel makes Voice Message Reports:
 After dialling, the Control Panel will delay 5 seconds then starts to play the message. It will first play the general part of the recorded message
(Address then plays the specific alarm message (Burglar, Fire, Medical or E mergency depending on the nature of the alarm.

To ensure the call is successfully received by the recipient, the recipient should acknowledge the message by pressing the appropriate button
on his telephone set.
 If the Control Panel does not receive any acknowledgement, the message will be repeated for 85 seconds. The Control Panel will then consider
the call unsuccessful and dial the next phone number in priority.
 If no phone number is programmed, the Control Panel will not dial.
key and enter a User PIN Code, then press
"Disarm"
key.
key.
OK
key on the Control Panel.
Disarm
key on the Remote Keypad.
16
OK.