Blaupunkt SA 2900R User Manual page 15

 Entry (E)
When the system is in any Arm mode, if an "Entry" device is triggered, the Control Panel will start an Entry Delay countdown timer for the user to
disarm the system.
After the delay period has expired and no correct PIN code has been entered, the Control Panel will activate iren immediately to remind the user
the delay period has expired.
If the Control Panel is not disarmed within 30 seconds after the delay period expires, a Burglar Alarm will be reported. Disarming the Control Panel
within the 30 second period will return the system to Disarm mode and silence the siren. No alarm will be reported.
When the system is in Disarm mode, if a "Entry" is triggered, the Control Panel will make a "ding-dong" Door Chime sound (if Door Chime function
is not disabled).
6. Enter a name for the device, press "OK" to confirm. You can also leave the name blank.
7. The screen will display the final device information, press "OK" to confirm and complete learning for the device
The device types are identified by the following abbreviation in the system:
 Door Contact ---- DC
 PIR Sensor ----- IR
 PET Immune PIR Sensor --- IRP
 Remote Controller --- RC

Remote Keypad ---KP
 Smoke Detector --- SD
 Temperature Sensor --- TS
 Outdoor Bell Box --- BX
6.5.2. Edit Devices
Use Edit Device to change setting for learned in devices. The screen will display available devices.
1. Select the device you want to edit, press "OK" to confirm.
2. Edit the device information according to the setting in Add Device.
6.5.3. Remove Devices
This function is used to remove an existing device from the system.
1. Select the device you want to remove, press "OK" to confirm.
2. You will be asked to confirm your action, press "OK" to confirm.
3. The device will be removed from the system.
6.6. SMS Keyword
The SMS Keyword is required if you want to remotely control the alarm system. When you send a SMS command to the Control Panel, the correct
Keyword must be entered in the SMS message for the Control Panel to recognize the command.
IMPORTANT NOTE: The SMS Keyword is capital letter sensitive. Please take care to note down whether your SMS Keyword is entered in upper case
or lower case
6.7. Reset GSM
Reset GSM
function allows you to reset your GSM module. You can reset the GSM if the Panel has GSM related fault conditions to try to solve the problem.
1. When you select the function, the screen will display
2. When GSM reset is complete, the screen will return to Programming Mode.
"Please wait".
Do not touch the Control Panel during the GSM reset process
14
SMS