IBM TS7650 Installation Roadmap Manual page 16

CAUTION:
v Do not install a unit in a rack where the internal rack ambient temperatures
v Do not install a unit in a rack where the air flow is compromised. Ensure that
v Consideration must be given to the connection of the equipment to the supply
v To provide the correct power connection to a rack, refer to the rating labels
v (For sliding modules.) Do not pull out or install any module or feature if the
v (For fixed modules.) This module is a fixed module and must not be moved for
(R001)
xvi
IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide
exceeds the manufacturer recommended ambient temperature for all your
rack-mounted devices.
air flow is not blocked or reduced on any side, front, or back of a unit used
for air flow through the unit.
circuit so that overloading of the circuits does not compromise the supply
wiring or over current protection.
located on the equipment in the rack to determine the total power
requirement of the supply circuit.
rack stabilizer brackets are not attached to the rack. Do not pull out more than
one module at a time. The rack might become unstable if you pull out more
than one module at a time.
servicing unless specified by manufacturer. Moving the module out of the
rack might cause the rack to become unstable or cause the module to fall out
of the rack.