IBM TS7650 Installation Roadmap Manual page 158

132
IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide
2. Run the ProtecTIER Manager installer. To do so:
a. From the Linux desktop, double-click the CD-ROM icon, and then
double-click the installation folder for the version of Linux you are using.
Linux for version 64 or Linux32 for version 32
b. From the installation folder, drag the InstallLinuxXX.bin file (where XX is
64 or 32, depending on the folder you are in) to the desktop.
c. Close any open windows.
d. Right-click any open area of the desktop, and then click Open Terminal.
The terminal window opens.
e. At the terminal command prompt, change to the Desktop directory. To do
so, type:
cd Desktop
and press the Enter key.
Note: This command is case-sensitive. Type it using a capital "D".
f. From the Terminal Window Desktop directory, run the ProtecTIER Manager
installer:
Note: In all commands below, XX is 64 or 32.
Type ./InstallLinuxXX.bin and press Enter.
If the message Permission denied displays, type the following two
commands:
chmod +x InstallLinuxXX.bin and press Enter
./InstallLinuxXX.bin and press Enter
The IBM ProtecTIER Manager Wizard Introduction screen displays.
3. Click Next.
Two separate Software License Agreement screens display.
4. Read the terms of agreement for each license, indicate your acceptance, and
then click Next.
The Choose Install Folder screen displays.
5. Specify the location for the ProtecTIER Manager program files. To do so,
perform one of the following:
v Enter the path to the destination location for the ProtecTIER Manager
program files.
v Click Choose to browse for a location.
Note: Click Restore Default Folder to revert to the default installation path.
6. Click Next.
The Choose Link Folder screen displays.