IBM TS7650 Installation Roadmap Manual page 148

2. Type the numeral corresponding to Health Monitoring and press Enter. The
3. Type the numeral corresponding to Run a full check on this node and press
4. If any health state returns a status of DEGRADED or FAILED, run the applicable
5. If all health states return a status of OK, exit the RAS menu.
6. Log out of the server.
7. If performing this procedure for a clustered configuration, disconnect the
8. Log in to Server B with the username root and password admin.
9. Repeat steps 1 on page 121 through 6 on Server B.
122
IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
----------------------------------------------------------------------
1) ProtecTIER Configuration (...)
2) Manage ProtecTIER services (...)
3) Health Monitoring (...)
4) Problem Alerting (...)
5) Version Information (...)
6) Generate a service report
7) Generate a system view
8) Update ProtecTIER code
E) Exit
----------------------------------------------------------------------
>>> Your choice?
Health Monitoring menu displays.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
Health Monitoring (...)
----------------------------------------------------------------------
1) Display health summary for this node
2) Display detailed health for this node
3) Run a full check on this node
4) Reset RSA/IMM
5) List open problems
6) Service Mode
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
Enter.
A series of messages displays, reporting the system health states. For example:
Begin Procedure: Verify storage and server installation
System health state: OK
Disk Array Health State is OK
Server Health State is OK
Adapters Health State is OK
Software Health State is OK
LocalFS Health State is OK
Battery Health State is OK
Network Health State is OK
individual health check selection to further diagnose the root cause of the
problem. If the root cause cannot be determined, contact your next level of
support.
keyboard and monitor from Server A and connect them to Server B.