Verifying The Complex Systems Attached To The Tssc; Ts3000 System Console, Attached Systems - IBM TS7650 Installation Roadmap Manual

8. Repeat steps 2 on page 88 through 5 on page 89 to configure RAS on Server B.
9. When RAS configuration is complete on both servers, go to "Verifying the

Verifying the complex systems attached to the TSSC

This section verifies the connection between the server and the TSSC and that the
newly added nodes are identified by the TSSC as attached systems. The TSSC can
collect the updated health information on demand.
Before you begin
If this server is already listed in the Attached Systems list as a complex system,
you can proceed to "Calibrating the server battery" on page 94.
Procedure
Perform the following steps to verify the complex systems attached to the TSSC.
1. If not already logged in to the TSSC, log in with the user ID service, and
2. Right-click the desktop and from the IBM TS3000 System Console menu, select
3. The TSSC network IP address of the TS7650 Appliance server is listed in the
Figure 50. TS3000 System Console, Attached Systems window
90
IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide
complex systems attached to the TSSC."
password service.
System Console Actions > Console Configuration Utility. If prompted for a
user name and password, enter service for both the user name and password.
From the icon menu list, select the Attached Systems icon.
Attached Systems window. See Figure 50 for an example of what this window
might look like, depending upon the systems in use at the customer site.