Table of Contents
Advertisement
10.
Remove the 2 storage stands from the rear of
the attachment.
1. Nut (4)
2. Storage stand
Adjusting the Working
Depth
1.
Raise the brushes to the highest position using
the electrical switch box.
2.
Engage the parking brake, shut off the engine,
and remove the key from the traction unit.
3.
Remove the hairpin cotter and pin from both
ends from each brush.
Figure 9
3. Bolt (4)
g349524
1. Pin
4.
Raise or lower the brushes to the desired
working height and install the pins and hairpin
cotters to the highest position beneath the
brushes.
5.
Adjust the other 3 pin locations to the same
height.
Important:
a way that could damage the topsoil.
6.
Verify the working depth while the attachment
is stationary.
9
Figure 10
Do not adjust the attachment in
g340431
Advertisement
Table of Contents
