Shared Sfp Transceiver Port Led State Indicators; Xfp Transceiver Port Led Indicators (5530-24Tfd Only) - Nortel 5500 series Installation Manual

Hide thumbs Also See for 5500 series:
Table of Contents

Advertisement

40 Installing the Nortel Ethernet Routing Switch

Shared SFP transceiver port LED state indicators

This section outlines the states indicated by the color and fluctuation cues
provided by the Shared SFP Transceiver Port LEDs.
Shared SFP transceiver Port LED state indicators
Label
In Use
LNK/AC
T

XFP transceiver port LED indicators (5530-24TFD only)

The Nortel Ethernet Routing Switch 5530-24TFD contains two XFP
Transceiver Ports with two LEDs labeled Tx (Transmit) and Rx (Receive).
"XFP transceiver port LED state indicators" (page 40)
indicated by the color and fluctuation of the XFP Transceiver Port LEDs.
XFP transceiver port LED state indicators
LED Color / Status
Tx Green / steady
Rx Green / steady
Tx Green / blinking
Rx Green / blinking
Tx Amber / steady
Rx Amber / steady
Tx Amber / blinking
The Amber LEDs are usually only used during the boot process. Under normal
operation, Green is the only color the XFP LED should emit.
Copyright © 2005 - 2006, Nortel Networks
.
Color / Status
Green / steady
Off
Green / steady
Green / blinking
Green / slow
blinking
Off
Note: The SFP Transceiver ports are shared. When a SFP Transceiver
is inserted and the port has a link established, the corresponding front
panel port is disabled. For more information on shared ports, refer to
the system configuration guide noted in
12)on page 16.
Nortel Ethernet Routing Switch 5500 Series
NN47200-300 2.00 Standard
5.0 7 July 2006
Description
A transceiver is inserted into the port.
The port has no transceiver.
This link is operating normally.
There is activity on the port.
The port has been disabled by the software.
Indicates that the link has been lost.
"Related publications" (page
Description
Link established.
Transmit activity detected.
Receive activity detected.
Transmit activity enabled.
Fiber connected with signal present.
XFP has been installed. Laser Transmitter OFF or
XFP in Reset.
Installation
outlines the port states
Nortel Networks Confidential

Advertisement

Table of Contents
loading

Table of Contents