Setting The Ip Address For The Management Interface - Nortel 2050 Installation Manual

Power connector

Setting the IP Address for the Management interface

N TPS 3D S
ORTEL ENSOR AND
3. Use an Ethernet cable to connect the management interface to a protected
network segment. The default IP address of the management interface is
192.168.45.45 with a Netmask of 255.255.255.0.
4. Turn on the Defense Center and continue with the next section,
IP Address for the Management interface" on page
Figure 6 TPS 2070 DC rear view
Serial port
NOTE: The Management interface corresponds to the eth0 Linux software
interface and there are no sensing interfaces on the Defense Center. The
unlabeled interface on the motherboard is not used.
In this section you set up the network interface that you will use later to administer
the Defense Center.
To configure the interface:
1. Connect to the Defense Center in one of the following ways:
• Connect a monitor and a keyboard to the Defense Center and set the
management interface to an IP address on the same subnet as the
administration system.
or
• Create an alias on the administration system that is on the same subnet as
the default IP address of the management interface (192.168.45.45) and
then access the Defense Center remotely using SSH.
2. Log in as root. The system requests a password.
3. Enter Nortel as the password. The password is case sensitive.
WARNING! Nortel strongly recommends that you change this password before
installing the Defense Center in a production environment.
4. To change the password, type passwd then enter the new password for root.
Be sure to document the new password.
D C I
EFENSE ENTER NSTALLATION
MGMT Management interface (eth 0)
G R 4.7.0
UIDE ELEASE
Chapter 2: Installation
TPS 2070 DC
"Setting the
26.
PAGE
26