Replacing The Usb Cable (Front Side) - Fujitsu PRIMERGY Econel 200 S2 Service Supplement Manual

Replacement routines
4.3

Replacing the USB cable (front side)

Part number: A3C40082391
Ê Remove the side cover as described in section "Opening the server" on
page 17.
Ê Remove the front cover as described in section "Removing the front cover"
on page 19.
Figure 6: Removing the screw of the holder
Ê Loosen the screw of the holder.
Ê Disconnect the plug of the USB cable from the system board (connector
USB 3/4, see system board foil D2530).
Ê Release the USB cable from the cable clamps, pull it through the recesses
of the chassis.
Econel 200 S2
Replacing the USB cable (front side)
Service Supplement 23