Removing The Front Cover - Fujitsu PRIMERGY Econel 200 S2 Service Supplement Manual

Replacement routines
Ê Disconnect the plug of the processor fan cable from the system board
(connector Fan1 CPU, see system board foil D2530).
Ê Pull the lock bar in direction of the front side.
Ê Pull the system fan a little forward to disengage its hooks at the rear side of
the server and take out the processor fan 1.
4.1.6

Removing the front cover

Ê Remove the side cover as described in section "Opening the server" on
page 17.
Figure 2: Opening the front cover
Ê Detach the three locking levers and open the front cover.
Econel 200 S2
Service Supplement
Preparation
19