Fujitsu PRIMERGY Econel 200 S2 Service Supplement Manual page 32

Replacing the system board
Figure 15: Removing the screws
Ê Remove the 6 screws from the system board.
Ê Lift the system board slightly using the marked socket of PCI slot 6 (see
arrow). In this way you lift the system board out of the centering ring of the
spacer bolt.
Ê Carefully remove the system board from the casing at a slight angle. This
allows you to pull the connectors out of the connector panel.
Ê Place the removed system board on an antistatic surface.
32 Service Supplement
Replacement routines
Econel 200 S2