Replacing The Chassis Id Board - Fujitsu PRIMERGY Econel 200 S2 Service Supplement Manual

Replacing the Chassis ID board

Ê Press sideward on the hooks of the new intrusion switch holder and press
the holder into the chassis.
Ê Install the processor fan 2 (for a detailed description see the Options Guide).
Ê Close the server (for a detailed description see the Options Guide) and
connect the power plug.
4.7 Replacing the Chassis ID board
Part number: T26139-Y3850-V229
Ê Remove the side cover as described in section "Preparation" on page 17.
Figure 14: Removing the Chassis ID board
Ê Remove the cable from the Chassis ID board (1).
Ê Loosen the screw (2) and remove the Chassis ID board.
Ê Insert the new Chassis ID board, fasten it with the screw and connect the
cable.
30 Service Supplement
Replacement routines
Econel 200 S2