Table of Contents
Advertisement
Safety
V
CAUTION!
●
The ON/OFF button does not disconnect the device from the mains
voltage. To disconnect the line voltage completely, remove the power
plug from the grounded insulated socket.
●
Always connect the device and the attached peripherals to the same
power circuit. Otherwise you run the risk of losing data if, for example,
the central processing unit is still running but the peripheral device
(e.g. an external drive) has failed during a power outage.
●
Data cables must be adequately shielded.
●
To the LAN wiring the requirements apply in accordance with the
standards EN 50173 and EN 50174-1/2.
As minimum requirement the use of a protected LAN line of category
5 for 10/100 MBps Ethernet, and/or of category 5e for Gigabit
Ethernet is considered.
The requirements of the specification ISO/IEC 11801 are to be
considered.
●
Route the cables in such a way that they do not form a potential
hazard (make sure no-one can trip over them) and that they cannot
be damaged. When connecting up a device, refer to the relevant
notes in this manual.
Never connect or disconnect data transmission lines during a storm
●
(lightning hazard).
●
Otherwise you run the risk of losing data if, for example, the central
processing unit is still running but the peripheral device (e.g. storage
subsystem) has failed during a power outage.
●
In emergencies (e.g. damaged casing, controls or cables, penetration
of liquids or foreign matter), switch OFF the device immediately,
remove the power plug and contact your sales outlet or customer
service team.
●
Proper operation of the system (in accordance with IEC 60950/EN
EN 60950) is only ensured if the casing is completely assembled and
the rear covers for the installation openings have been put in place
(electric shock, cooling, fire protection, interference suppression).
12
Service Supplement
Econel 200 S2
Advertisement
Table of Contents
