Procedure - Fujitsu PRIMERGY Econel 200 S2 Service Supplement Manual

2

Procedure

V
CAUTION!
The actions described in this manual should only be performed by
service personnel.
Ê Before doing anything else, please take notice of
page 11 et seq. .
Ê Make sure all necessary manuals (see service DVD) are available; possibly
print of the PDF files. You will definitely need the Operating Manual for the
server, the Options Guide for the server and the Technical Manual for the
system board.
Ê Shut down the server correctly, switch it off, pull out the power plug, and
open the server as described in the
page 17 et seq. .
Ê Replace the defective component as described in the relevant chapter.
Ê Close the server.
Ê Connect the cables.
Ê Connect the server to the line voltage.
Ê Start the operating system.
Ê If necessary, configure the server as required.
Econel 200 S2
chapter "Replacement routines" on
Service Supplement
chapter "Safety notes" on
9