JUMO LOGOSCREEN 700 Brief Instructions page 86

6 Annex
Enter batch texts
Step
1
All batch lines configured for the barcode input are populated with the scanned text one after the other
(max. 160 characters). The last line is overwritten in the case of further entries.
If there is a dollar character (default setting, configurable) within the scanned text, this causes the text
following the dollar character to be entered in the next line. In this way one scan operation can populate
up to 10 lines. Several dollar characters stringed together cause the corresponding number of line
breaks.
A maximum of 480 characters (incl. the characters for the line break) can be entered with one scan op-
eration (e.g. 3 lines of 159 characters each or 10 lines of 47 characters each).
NOTE!
The batch control codes (BATCH..., START, STOP, RESET) cannot be loaded as batch texts.
Reset texts
Step
1
The entered batch texts are reset. The standard texts (default texts) are displayed and the first line is
prepared for text entry again.
The standard text is specified in the configuration of the batch line (Configuration > Batch > Batch line:
Default text).
Start batch reporting
Step
1
Batch reporting is started.
86
Action
Scan the barcodes for the batch text of the individual lines one after the other (starting with
the first line).
Action
Scan the RESET barcode.
Action
Scan the START barcode.
RESET
START