Furuno TZT12F Installation Manual page 57

8. Tap the appropriate WLAN network to show the following display.
9. Tap [Connect], and the following display appears.
10. Use the software keyboard to enter the network key, then tap the [OK] button. To
see what you have input, check [Show characters].
Note: If the network key is incorrect, an error message appears. Enter the correct
key and tap [OK] again.
11. Tap [X] on the title bar to close the menu.
3.6.2 How to create a wireless LAN network
Smart devices connected to this wireless network may also connect directly to the unit,
allowing use of the TZT12F applications.
1. Tap the Home icon (
tings.
2. Tap [Settings] then [General].
3. Tap [Wireless LAN Settings].
4. Tap [Wireless Mode] in the [WIRELESS MODE] menu.
5. Tap [Create Local Network] to show a
the display.
6. Tap [Name] in the [LOCAL NETWORK SETTINGS] menu.
7. Using the software keyboard, name the unit, then tap the
8. Tap [Password] in the [LOCAL NETWORK SETTINGS] menu.
9. Using the software keyboard, set the password, then tap the
10. Tap [Local Network] in the [ENABLE LOCAL NETWORK] menu to activate the
wireless network.
11. Your smart device may now be connected to the unit, through the network.
1) From the smart device, select the network set at step 7.
2) Input the password set at step 9.
12. Tap [X] on the title bar to close the menu.
CANCEL
FORGET
CONNECT
ENTER WIRELESS NETWORK KEY
Show characters
CANCEL
) to show the home screen and display mode set-
3. HOW TO SET UP THE EQUIPMENT
, then tap the [<] icon at the top left of
.
.
3-21