Furuno TZT12F Installation Manual page 11

7. Attach the flush mount fixture to the TZT12F with hex bolts.
① ① Attach the flush mounting Attach the flush mounting
plate to the TZT12F. plate to the TZT12F.
8. Fasten each wing bolt (4 pcs.) so that the protector for screw touches the mount-
ing panel.
9. Fasten the wing nuts tightly.
Note: Use of excessive torque when fastening the wing bolts can cause the flush
mount fixture to tilt or warp. Check that the flush mount fixtures and wing bolts are
not tilted or warped, referring to the following examples.
Flush mount fixture is fixed at right angle.
② ②
Set TZT12F to the cutout.
Wing bolt
TZT unit TZT unit
Wing nut
Flush mounting fixture
Protector for screw
Mounting panel
Flush mount fixture is warped, wing bolts are tilted.
1. MOUNTING
1-3