1.1.3
Desktop mounting (option)
Follow the appropriate procedure below to mount the TZT12F.
Use the optional kit Bracket12 (contents shown below), for mounting the TZT12F.
Bracket 12
Knob (N1)
Washer
Self-tapping screw
1. Fix the hanger by using self-tapping screws (5 20 SUS304, supplied). The screw
locations are indicated in the figure below.
2. Place the TZT12F face-down on a soft, clean surface, then fit the washers and
knob bolts as shown in the figure below, leaving a gap of approximately 30 mm.
The washers have a leading edge which must face the unit.
Knob
Type: OP19-20 Code No. 001-563-930
Name
OP19-20-1
19-033-1001-0
05-024-0123-1
5X20 SUS304
Washer
Type
001-563-320-00
100-418-430-10
100-076-101-10
000-162-608-10
Washer leading edge
1. MOUNTING
Code No.
Qty
1
2
2
4
Washer
Knob
1-5