Table of Contents
Advertisement
[Initial Setup] menu - [DATA ACQUISITION]
Menu Item
[GP330B WAAS Mode]
[WS200 WAAS Mode]
[Data Source]
[Sensor List]
[NMEA0183 Output]
Note: If the TTM sentence
is received at the same
time as another sentence,
the constraints to commu-
nication bandwidth may
cause a decrease in the
number of TTM targets.
[NMEA2000 PGN Output]
[Sky View]
[Initial Setup] menu - [NMEA2000 LOG]
Menu Item
[Enable NMEA2000 Log]
[NMEA2000 Log Storage
Location]
[Initial Setup] menu - [INTERNAL GPS SETUP]
Menu Item
[WAAS Mode]
[Initial Setup] menu - [SC-30 SETUP]
This menu is only available with SC-30 connection.
Menu item
[WAAS Mode]
Select [ON] to use the WAAS mode.
[Heading Offset]
Enter the offset value for heading.
[Pitch Offset]
Enter the offset value for pitching.
[Roll Offset]
Enter the offset value for rolling.
[Initial Setup] menu - [NETWORK SENSOR SETUP]
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
Tap the sensor to access its menus and settings. For details regarding the menu struc-
ture and set up of each sensor, see the operator's manual supplied with the sensor.
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The FURUNO products are shown at the upper part of the list.
Show the information for sensors connected to your equipment. Also,
you can set "Nickname" for them here.
[Port Configuration] - [Baud Rate]: Select
the output baud rate.
[Port Configuration] - [NMEA-0183 Ver-
sion]: Select the NMEA0183 version for
output.
[Sentences]: Select the sentences to out-
put.
Select [ON] for the PGN's (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
Show the condition of GPS and GEO (WAAS) satellites. Number, bear-
ing and elevation angle of all GPS and GEO satellites (if applicable) in
view of your GPS receiver appear.
Description
Set to [ON] when using NMEA2000 log.
Show the location where to store the log.
Description
Set to [ON] to use the WAAS mode.
Description
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
[ON], [OFF]
[4,800], [9,600], [38,400]
[1.5], [2.0], [3.0]
[ON], [OFF]
Options (setting range)
[ON], [OFF]
Options (setting range)
[ON], [OFF]
Options (setting range)
[ON], [OFF]
-180° to +180°
-90° to +90°
-90° to +90°
3-9
Hide quick links:
Advertisement
Table of Contents
