Furuno TZT12F Installation Manual page 30

2. WIRING
2.8.1 How to connect the NavNet Tztouch3 to CAN bus equipment
Below is an example of two NavNet Tztouch3 units, connected via CAN bus to CAN
bus sensors.
Ethernet cable Ethernet cable
2.8.2 How to connect Yamaha engine(s)
When interfaced with Yamaha outboard engine(s) compatible with Command Link
Command Link Plus
on a dedicated Yamaha engine status display.
How to connect the engine
The TZT12F connects to the Yamaha engine network via the Yamaha Interface Unit.
Arrange the Yamaha Interface Unit through a local Yamaha representative.
The Yamaha Engine Hub (Yamaha supply), which connects between the engine and
the Yamaha Interface Unit, is also required.
2-6
TZT12/16/19F
CAN bus cable CAN bus cable
TZT12/16/19F
®
and Helm Master
Yamaha Interface Unit
To Yamaha Engine Hub
(Command Link cable)
To NMEA 2000 Backbone
(Micro-C cable(Male))
Yamaha Engine Hub
to CAN bus sensors to CAN bus sensors
®
, the TZT12F can display engine information
®
,