Reconfiguration Of The Iplex Using The Serial Port - Ericsson TANDBERG Television iPlex N20001 Installation Manual

iPlex Installation and Hardware Specification Guide
Confirmation
Reconfiguration
of the iPlex Using
the Serial Port
80
R e t y p e
[ M i s m a t c h ]
The CANCEL key doesn't abort the procedure; rather, it brings you to the previ-
ous step. For example, if the CANCEL key is pressed while retyping password, you
are asked to enter new password.
Some menu items ask a Yes/No selection. For example, when the front panel is
unlocked, selecting the "lock/unlock" menu item will ask you whether to lock the
front panel. The first line shows the title and the second line shows the choice. The
cursor moves between Y and N character.
L o c k i t ?
Y e s / N o
NOTE
You must interrupt the boot within 5 seconds after applying power by
using the CNTL-x CNTL-w key sequence in order to configure the
iPlex using the serial port.
When you first install your iPlex to reconfigure the bootload, connect a manage-
ment workstation to the iPlex through the serial port. Turn on the main power
switch on the iPlex chassis, and by using 9800 Baud HyperTerminal for Windows
(or equivalent) and specifying the appropriate parameters, the initial screen will
automatically launch a command prompt screen containing the following options:
1. Setup the IP Addresses
2. Setup the root password
3. Setup the Default Gateway Address
4. Setup the Subnet Mask
5. Enable DHCP Boot
6. Enable TFTP boot (*)
7. Enable boot from FLASH (partition#1)
8. Enable boot from FLASH (partition#2)
9. Set Date and Time
10. Go to boot from prompt
11. Boot iPlex
Choose an option:
NOTE
(*) indicates the location of the default boot image.
p a s s w o r d :