Installing A Carrier Card - Ericsson TANDBERG Television iPlex N20001 Installation Manual

iPlex Installation and Hardware Specification Guide
62
4 Fasten the submodule to the carrier card from the back with four screws.
1
2
NOTE The submodules in PMC slots 1 to 4 use a countersunk head screw under
the ejector pivot points.
5 Reinstall the carrier card in the iPlex chassis.
To install a blank plate:
If you have an open submodule slot in the carrier card, you must fill it with a blank
plate. Snap it in from the front of the blade. To remove a blank plate you just push
it out from the inside.

Installing a Carrier Card

The carrier card is installed in either slot 1 or slot 2 of the iPlex chassis. The fol-
lowing steps are required to install a carrier card in an iPlex chassis.
ATTENTION!
If there is only one carrier card in the iPlex system it must be
installed in the top slot, carrier card slot 1. A blank face plate must
be installed in the bottom slot, carrier card slot 2.
WARNING
The carrier card is NOT hot swappable. Do not remove or install
the carrier card while the iPlex chassis has power or damage may
occur.
3
4