Ericsson TANDBERG Television iPlex N20001 Installation Manual page 78

iPlex Installation and Hardware Specification Guide
Editing the Data
Entry Fields
78
When a menu item requires an input from you, the prompt message is displayed
on the first line and a '>' character is displayed on the first column of the second
line to note that it is the beginning of the data entry field. The rightmost column is
used to display the arrows if the entry field consists of multiple lines. The left and
right key are used to move the cursor, and up and down key are used to change the
character.
There are more than four types of basic data entry fields:
•
string—a multiple line data entry field. It can also be used to get password input where all the
characters but the character where the cursor is located will be shown as asterisk ('*').
•
date—a single line field.
•
time—a single line field.
•
IP address—a single line field.
String Field
The following is the example of string field. It works as overwrite mode. You can
change the character on the cursor. Only the last character in the string can be
deleted by selecting the space character. This character is not in the selectable char-
acter set if the cursor is in the middle of string (i.e., no space is allowed in a string.)
E n t e r f i l e n a m e :
> / t f t p b o o t / l a t e
> / t f t p b o o t / l a t e
s t / t e s t / n m r - i m
s t / t e s t / n m r - i m
a g e
Two extended keys make editing easier. If the enter key is pressed for a second,
extended enter key code is generated and the edit menu appears.
E d i t
1 . R e s e t
2 . I n s e r t
3 . D e l e t e
4 . D e l e t e
5 . C l e a r
6 . C l e a r
•
The 'Reset' command restore the initial string.
•
The 'Insert a letter' command inserts a letter into the cursor if the string is not maxed out.
•
The 'Delete a letter' and 'Delete a word' command deletes a letter and a word on cursor
respectively.
•
The 'Clear to end' command deletes character from the cursor.
c m d s
l e t t e r
l e t t e r
a w o r d
t o e n d
a l l