Switch Control Module (Scm) And Media Control Module (Mcm) - Ericsson TANDBERG Television iPlex N20001 Installation Manual

1
1
Switch Control
Module (SCM)
and Media
Control Module
(MCM)
iPlex Installation and Hardware Specification Guide
a serial interface console port for local system access to the command line inter-
face (CLI), and an alarm port.
STA TU
S
AC TIV E
POW ER LIN K AC
SCM TIV E
ONL INE ETH 1 AL AR M
GE 1
MCM
MAJ OR
ETH 2
GE 2
MIN OR
1
2
3
The iPlex is NEBS Level 3 certified. It provides room for 8 submodule slots.
The close-up rear view image below shows a full chassis with eight submodules, a
console port, an alarm port, a control port, a redundancy port, and two GE ports.
2
2
iPlex is capable of supporting up to 2 Gbps of bandwidth through the backplane
and routing or switching data traffic at wire speed.
The Media Control Module is a portion of the iPlex system board that provides
submodule connectivity via the carrier card. The carrier card provides a standards-
based mezzanine interface for up to four submodule cards per carrier card, and up
to two carrier cards per chassis (thus up to eight submodule cards per iPlex).
Front View
4
CO NS OLE
100 /24 0
VAC ~6 A
RED UND
ANC Y GE 1
ALA RM
CO NTR
OL
GE 2
Rear View
3 4
3 4
Close-up Rear View
CONSOLE 100/240 VAC~6A
GE1
REDUNDANCY
ALARM
CONTROL
GE2
17