Table of Contents
Advertisement
iPlex Installation and Hardware Specification Guide
Rack-mount
Instructions
Rack-mount Check
List
Installation
Instructions
Step 1
28
2 Confirm the contents of the accessory kit have been received, as follows:
6 foot AC Power cord
■
19" Rack Mounting brackets and chassis mounting screws
■
iPlex CD ROM package
■
iPlex Quick Start Guide
■
Declaration of Conformity
■
3 Check if optional items ordered such as audio cable assemblies were included
4 The iPlex comes pre-configured with the number and type of interface
submodules installed. Verify the configuration matches the packing slip and
that all submodules and SFP interface modules have been properly installed.
Installing the iPlex Chassis
The following instructions will guide you through installing your iPlex chassis into
a typical rack-mount cabinet or chassis.
The iPlex chassis rack-mount kit includes:
Two (2) 19" rack-mount brackets
■
Twelve (12) 8-32 Phillips countersunk screws to secure the rack mount brackets
■
to the chassis.
Additional items supplied by customer:
19 inch EIA or broadcast equipment rack
■
Four (4) rack-mount screws (rack specific) for rack-mount support brackets
■
#2 Phillips screwdriver (as required)
■
Tape measure
■
Marker (to mark position)
■
The steps to follow to install the chassis are outlined below.
Install only in a restricted access location in accordance with Local Codes.
Attach the rack-mount brackets to the chassis using the Phillips countersunk rack-
mount screws.
Hide quick links:
Advertisement
Table of Contents
