Electro-Voice EVOLVE Installation Manual page 34

34 en | Mixer operation
Menu item
OUTPUT SETTINGS
DEVICE SETUP 1
DEVICE SETUP 2
2019-08 | 01 |
Subitems/parameter range
(default setting in bold)
– MAS. B Delay: : 0.0-50
Meters
– DIRECT DRIVE: Off,
On/50Hz HPF, On/70Hz
HPF
– AMP ROUTING: MASTER A,
MASTER B, AUX, Dual A - B,
Dual A - AUX, Dual B - AUX
– AUX Mode: AUX-Bus, MAS.
A Pre, MAS. A Post
Limiters:
– MASTER A: -10 - +11 dBu
– MASTER B: -10 - +11 dBu
– AUX Limiter: -10 - +11 dBu
– LCD Auto Dim: Off-60 Min.
– Dim Brightness: 0-100%
– Screensaver: Off-60 Min.
(default: Off)
– Personalize
– Lock/Unlock: 0000-9999
– Lock Mode: Custom, Level
1,2,3
Installation manual
EVOLVE Portable Column Loudspeaker
Description
affected by the MASTER A control's
setting. When MASTER B is set to
Post, the audio signal is tapped
post MASTER A volume control and
therefore affected by the MASTER A
control's setting. This mode is
mainly used for subwoofers or
delay lines.
When MASTER B is set to Stereo,
the MASTER B L/R signal is not
changed and outputted in stereo.
When Mono is selected the
MASTER B L/R signal is summed
and outputted in mono at MASTER
B L and also MASTER B R.
The MASTER B signal can be
delayed up to 145.8 ms. The unit
can be switched between
milliseconds (ms), meters and feet.
In this menu you can configure
advanced features of the EVOLVE
column speaker outputs. Please
refer to the corresponding sections
for more details:
– 100 V Direct Drive
– Amplifier routing
– AUX sources
The audio limiter thresholds can be
set independently for the MASTER
A, MASTER B or AUX output signals.
After the time set here the display
brightness is dimmed. The
brightness of the display in dimmed
mode can be adapted to the
installation location.
After the time set here the
screensaver is activated. You can
personalize the device name shown
in the screensaver screen.
Enter a 4 digit PIN (password) to
lock certain parameters of the
EVOLVE column speaker. Please
refer to section Locking for more
details.
Electro-Voice