Electro-Voice EVOLVE Installation Manual page 33

EVOLVE Portable Column Loudspeaker
Menu item
SPEAKER PROC
MASTER A EQ
MASTER B EQ
AUX EQ
MASTER ROUTING
Electro-Voice
Subitems/parameter range
(default setting in bold)
– COMPRESSOR TYPE: 2:1
Ratio, 4:1 Ratio, Limiter,
Uplift Soft
– COMPRESSOR ATTACK:
1-1000 ms
– COMPRESSOR RELEASE:
50-10000 ms
– COMPRESSOR MAKEUP
GAIN: 0 - +6 dB
– TALK OVER PRESET:
Announcer, Singer,
Instructor, Presenter
– TALK OVER THRESHOLD:
-50 - -10 dB
– TALK OVER DAMPING:
-100-0 dB
– TALK OVER ATTACK:
0-1000ms
– TALKOVER HOLD: 0.0-99.9s
– TALK OVER RELEASE:
0.1-30.0s
– Low Pass Notch: Flat,
Medium, High
– SLIDERS-LINK
– Frequency bands 63 Hz,
160 Hz, 400 Hz, 1 kHz,
2.5 kHz, 6 kHz, 12 kHz
– MASTER A: Mono, Stereo
– MASTER B: Pre, Post;
Mono, Stereo
Installation manual
Mixer operation | en
Description
The talk over settings allow
adjusting the microphone
processing to your application.
Please refer to section Microphone
processing (TALK OVER) for more
details.
This menu is used to edit the LPN
Speaker Processing filter setting of
the integrated power amplifiers.
Please refer to section Speaker
processing (LPN) for more details.
If the DIRECT DRIVE mode is
activated, the Low Pass Notch filter
is always bypassed.
Activate the entry SLIDERS-LINK to
edit the levels of the corresponding
GEQ bands using the GEQ
hardware controls. If not activated,
edit the bands in the display using
the FX/PARAMETER rotary control.
When MASTER A is set to Stereo,
the MASTER A L/R signal is not
changed and outputted in stereo.
When Mono is selected the
MASTER A L/R signal is summed
and outputted in mono at MASTER
A L and also MASTER A R.
When MASTER B is set to Pre, the
audio signal is tapped pre MASTER
A volume control and therefore not
33
2019-08 | 01 |