Table of Contents
Advertisement
30
en | Mixer operation
5.
6.
7.
8.
Pay attention to the PK indicators when operating your EVOLVE to be able to respond quickly
when the signal levels exceed the normal range and start clipping.
VOLUME control
This control is used to determine the amount of effect added to the master mix. If you find
that you have to set these controls above the "8" mark, please check if the FX unit's input
signals are adjusted properly.
8.4
AUX
Indicators
It is acceptable for the LIM indicator to flicker from time to time because the built in clip
limiter prevents distortion. If it is lit continuously, you are at risk of the degradation of your
speaker output. In that case, the volume level has to be reduced. The limiter threshold can be
edited in the OUTPUT SETTINGS menu, please refer to section Menu.
Below the LIM indicator, the EVOLVE offers a 3-segment LED chain for visual monitoring of the
output level of the signal. The meter's 0 dB mark is referenced to a 0 dBu output signal at the
mixer output.
VOLUME control
The VOLUME control sets the volume of the summed audio signal at the AUX OUT output. The
signal present at this output can be selected in the AUX routing menu, please refer to section
Menu.
8.5
MASTER
Indicators
It is acceptable for the LIM indicator to flicker from time to time because the built in clip
limiter prevents distortion. If it is lit continuously, you are at risk of the degradation of your
speaker output. In that case, the volume level has to be reduced. The limiter threshold can be
edited in the OUTPUT SETTINGS menu, please refer to section Menu.
Below the LIM indicator, the EVOLVE column speaker offers a 3-segment LED chain for visual
monitoring of the output level of the signal. The meter's 0 dB mark is referenced to a 0 dBu
output signal at the mixer output.
VOLUME control
Level controls to adjust the output signals of the left and right master outputs (MASTER A or
MASTER B). If post mode is selected for MASTER B (see section Menu) set the MASTER B
level control to its middle position for identical levels on MASTER A or B outputs.
8.6
Microphone processing
During operation the audio signal processing can be adjusted by using the switches
COMPRESSOR, TALK OVER or MUTE, this settings always affect the input signals of all MIC/
LINE channels. The current status is indicated by the corresponding LED next to each button.
Advanced microphone processing settings are available in the menu, please refer to section
Menu.
2019-08 | 01 |
Play the sound source connected to the desired input channel and adjust the desired
amount of the FX signal, using the FX controls of this input channel. Repeat this step for
all input channels that you want to include in your effect mix.
Monitor the PK LED so that it only lights up from time to time during signal peaks. When
clipping occurs, reduce the channels FX control level.
Use the FX to AUX control to add the effect mix to the AUX mix.
Use the FX VOLUME control to add the desired amount of the FX signal to the master mix.
Installation manual
EVOLVE Portable Column Loudspeaker
Electro-Voice
Advertisement
Table of Contents
