LEDs
System status LED
The system status LED shows the operating state of the switch.
Table 23 System status LED description
LED mark
SYS
Power module status LED
The S5130-30C-HI, S5130-34C-HI, S5130-54C-HI, S5130-30F-HI, S5130-30C-PWR-HI, and
S5130-54C-PWR-HI switches provide two power module slots at the rear. For each power module,
these switches provide a power module status LED on the front panel.
Table 24 Power module status LED description
LED mark
PWR1
PWR2
RPS status LED
The S5130-30S-HI and S5130-54S-HI switches support RPS DC input. The RPS status LED shows
the status of the RPS DC input.
Table 25 RPS status LED description
LED mark
RPS
Status
Steady green
Flashing green (1 Hz)
Steady red
Flashing yellow (1 Hz)
Off
Status
Description
A power module is installed in power module slot 1, and the power
Steady green
module is outputting power correctly.
A power module is installed in power module slot 1, but the power
Steady yellow
module has failed or no power is input to the power module.
Off
No power module is installed in power module slot 1.
A power module is installed in power module slot 2, and the power
Steady green
module is outputting power correctly.
A power module is installed in power module slot 2, but the power
Steady yellow
module has failed or no power is input to the power module.
Off
No power module is installed in power module slot 2.
Status
Steady green
Steady yellow
Description
The switch is operating correctly.
The switch is performing power-on self test (POST).
The switch has failed the POST or is faulty.
Some ports have failed to pass POST or are faulty.
The switch is powered off.
Description
Both the RPS DC input and the AC input are normal.
The RPS DC input is normal, but the AC input is disconnected or
has failed.
76