Table of Contents
Advertisement
LED mark
Port mode LED
To show more information about the switch through the port status LEDs, all S5130-HI switches
except the S5130-54QS-HI switch provides a port mode LED. The port mode LED indicates the type
of information that the network port LEDs are showing.
Table 26 Port mode LED description
LED mark
Mode
10/100/1000BASE-T autosensing Ethernet port LED
The switch provides a status LED for each 10/100/1000BASE-T autosensing Ethernet port. The port
status LED and the port mode LED indicate the operating state of the 10/100/1000BASE-T
autosensing Ethernet port in conjunction.
Table 27 10/100/1000BASE-T autosensing Ethernet port LED description
Port mode LED (Mode)
status
Steady green (rate mode)
Flashing green (1 Hz) (PoE mode,
available only for
S5130-30C-PWR-HI and
S5130-54C-PWR-HI switches)
Flashing yellow (IRF mode)
Status
Off
Status
Steady green
Flashing green (1 Hz) (available only for
S5130-30C-PWR-HI and
S5130-54C-PWR-HI switches)
Flashing yellow
Port LED status
Steady green
Steady yellow
Flashing yellow (3 Hz)
Off
Steady green
Flashing green (3 Hz)
Steady yellow
Flashing yellow (3 Hz)
Off
Steady green
Description
The RPS DC input is abnormal or no RPS is connected.
Description
The port status LEDs are showing port rates.
The port status LEDs are showing the status
of PoE power supply on the ports.
The port status LEDs indicates the IRF
member ID of the switch. For example, if the
ports 1 to 5 are steady green, the IRF
member ID of the switch is 5.
Description
The port is operating at 1000 Mbps. The port
LED fast flashes when the port is sending or
receiving data.
The port is operating at 10/100 Mbps. The
port LED fast flashes when the port is
sending or receiving data.
POST has failed on the port.
No link is present on the port.
PoE power supply is normal.
The device attached to the port requires
power higher than the maximum or currently
available PoE output power on the port.
The port is experiencing a PoE failure.
POST has failed on the port.
The port is not supplying PoE power.
The port status LED indicates the IRF
member ID of the switch. For example, if the
ports 1 to 5 are steady green, the IRF
77
Advertisement
Table of Contents
