Internal Ports; Leds - H3C UniServer BX720EF User Manual

3
4
5
For details about the optical modules and cables supported by the switch module as well as their
specifications, see

Internal ports

Table 3 shows the internal port provided by the switch module.
Table 3 Description of the internal port
Port
Name
10GE port

LEDs

Figure 4 shows positions and appearance of LEDs on the switch module.
colors and the corresponding meaning.
Convergent port
10GE optical interface
40GE optical interface
"Compatibility between switch modules and optical
Port
Port Type
Quantity
N/A
38
ZSFP+ 8
SFP+ 8
QSFP+ 4
Description
•
A total of 32 ports are provided to connect to blade servers.
The port number ranges from XGE1/0/1 to XGE1/0/32.
•
Used to connect to switch modules installed in pairs in slots 1
and 4, 2 and 5, and 3 and 6. The ports are numbered from
XGE1/0/33 through XGE1/0/36. The four ports are
connected to each other through the mid plane. As a best
practice, use the ports as physical ports for IRF connection.
•
A total of 2 ports are provided to connect to AE modules,
where only switch modules in slot 1 and slot 4, with the ports
numbered XGE1/0/37 through XGE1/0/38, are connected to
the AE modules.
5
•
Eight ports are divided into two
groups. Ports 1–4 are in a
group, and ports 5–8 are in a
group.
•
Each port can be switched over
between Ethernet port and FC
port. By default, the port works
as an Ethernet port.
•
Port switching is conducted in
the unit of groups. You can
uniformly switch a group of
ports from Ethernet ports to FC
ports or from FC ports to
Ethernet ports through the ICM
CLI. For specific switching
methods, see "Switching
convergent port type."
Support for FCoE
Support for FCoE
modules/cables."
Table 4 describes LED