Rack-Mounting By Using Front And Rear Mounting Brackets - H3C S5130-HI Series Installation Manual

Rack-mounting by using front and rear mounting brackets

This mounting method is applicable only to the S5130-30C-PWR-HI, S5130-54C-PWR-HI, and
S5130-54QS-HI switches. You can install the front mounting brackets at the port-side or power-side
mounting position as needed. The following takes port-side mounting as an example. The
power-side mounting is similar.
This task requires two people.
To install the switch in a 19-inch rack by using the front and rear mounting brackets:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Attach the front mounting brackets and shoulder screws to the chassis:
2.
a. Unpack the front mounting brackets and the M4 screws for attaching the brackets to the
switch chassis.
b. Align the round holes in the wide flange of one front mounting bracket with the screw holes
in the port-side mounting position on one side of the chassis (see
c. Use M4 screws (supplied with the switch) to attach the mounting bracket to the chassis.
d. Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
e. Unpack the shoulder screws. Attach the shoulder screw to one of the two installation
positions as red-marked in
Figure 12 Attaching the front mounting brackets and shoulder screws to the chassis
(S5130-30C-PWR-HI/S5130-54C-PWR-HI)
Figure 13 Attaching the front mounting brackets and shoulder screws to the chassis
(S5130-54QS-HI)
Figure 12 and Figure
11
Figure 12
13.
and Figure 13).