Table of Contents
Advertisement
Figure 26 Grounding the switch by burying the grounding conductor into the earth ground
1
(1) Grounding screw
(4) Earth
Installing/removing a fan tray
CAUTION:
• Install two fan trays of the same model on the switch. Do not power on the switch when it does
not have a fan tray or has only one fan tray installed.
• Make sure slots are installed with fan trays or blank filler panels for the device to operate.
• If both fan trays fail during operation, replace them within 2 minutes while the switch is operating.
• If one fan tray fails, perform either of the following tasks:
If the ambient temperature is not higher than 27°C (80.6°F), replace the fan tray within 24 hours and
make sure the failed fan tray is in position before the replacement.
If the ambient temperature is higher than 27°C (80.6°F), replace the fan tray immediately.
The
S5130-30F-HI,
S5130-54C-PWR-HI, and S5130-54QS-HI switches support hot-swappable fan trays.
The switch comes with empty fan tray slots. Choose the fan tray models based on the ventilation
requirement of the site. The air flow direction varies by fan tray model.
•
The LSPM1FANSA has a blue handle and provides power-to-port air flow.
•
The LSPM1FANSB has a red handle and provides port-to-power air flow.
For more information about the fan trays, see
Installing a fan tray
CAUTION:
To prevent damage to the fan tray or the connectors on the backplane, insert the fan tray gently. If
you encounter a hard resistance while inserting the fan tray, pull out the fan tray and insert it again.
To install a fan tray:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Unpack the fan tray and verify that the fan tray model is correct.
2.
2
3
4
5
6
(2) Chassis rear panel
(5) Joint
S5130-30C-HI,
S5130-34C-HI,
20
S5130-54C-HI,
"Appendix B FRUs and compatibility
(3) Grounding cable
(6) Grounding conductor
S5130-30C-PWR-HI,
matrixes."
Advertisement
Table of Contents
