Table of Contents
Advertisement
Figure 2 Installation flow
NOTE:
If the power module slot does not have a blank panel, skip the
"Remove the blank panel" procedure.
Before installing the power module, prepare an ESD wrist strap and a
Phillips screwdriver.
Installing the power module
1.
Wear an ESD wrist strap, and make sure the wrist strap makes
good skin contact and is reliably grounded.
2.
Use the Phillips screwdriver to loosen the captive screw on the
blank panel in the target slot, and remove the blank panel.
3.
Take the power module out of the package.
7
Advertisement
Table of Contents
Need help?
Do you have a question about the SecPath AC2500 and is the answer not in the manual?
Questions and answers