Table of Contents
Advertisement
Installing and removing the power
module
The installation and removal procedures are the same for the
PSR650C-12A and PSR650C-12D power modules. This section
uses the PSR650C-12A as an example.
Safety precautions
To avoid possible bodily injury and power module and device
damage, follow these safety precautions:
•
When you install and remove the power module, always wear an
ESD wrist strap and make sure it makes good skin contact and
is reliably grounded.
•
Before you install the power module, make sure the output
voltage of the power module is as required by the device.
•
When you move the power module, support its bottom instead of
only holding the power handle.
•
To avoid device damage, do not install power modules of
different models on the same device.
•
Do not touch any bare cables or terminals of the power module.
•
Do not place the power module in a wet area, and prevent liquid
from flowing into the power module.
•
Do not open the power module. When the internal circuits or
components of the power module fail, contact H3C Support.
Installing the power module
WARNING!
Turn off the power switch before installing the power module.
5
Advertisement
Table of Contents
