Table of Contents
Advertisement
Figure 8 Removal flow
Before removing the power module, prepare an ESD wrist strap and
a Phillips screwdriver.
Removing the power cord
1.
Turn off the circuit breaker of the power cord.
2.
Wear an ESD wrist strap, and make sure the wrist strap makes
good skin contact and is reliably grounded.
3.
Remove the cable tie, and pull the power cord plug out.
Removing the power module
CAUTION:
Before you insert a removed power module into a power module
slot, make sure the LEDs on the power module are off.
12
Advertisement
Table of Contents
Need help?
Do you have a question about the SecPath AC2500 and is the answer not in the manual?
Questions and answers