Table of Contents
Advertisement
1.
Use the Phillips screwdriver to loosen the captive screw on the
power module.
2.
Hold the captive screw and pull out the handle of the power
module.
3.
As shown in
with one hand and pull it part way out of the slot. Support the
bottom of the power module with the other hand, and pull the
module slowly out of the slot along the guide rails.
Figure 9 Removing the power module (vertical power module
slot)
4.
Put the power module on an antistatic mat.
5.
Install the blank panel in the power module slot, and fasten the
captive screw on the blank panel.
Figure
9, grasp the handle of the power module
13
Advertisement
Table of Contents
Need help?
Do you have a question about the SecPath AC2500 and is the answer not in the manual?
Questions and answers