Setting Up The Pc To Configure The Modem - ADC 400F User Manual

Setting Up the PC To Configure the Modem

S U
ETTING P THE
Configure the Megabit Modem 400F using a PC connected to the 10/100BASE-T port. The PC
must be set to
Specify an IP address
card that is on the same subnet as the IP address for the modem. If you want to view or change
the default IP address for the modem, see
The following is an example of how to set up the PC using Microsoft Windows
use an operating system other than Windows 95, refer to the appropriate operating system user
documentation.
1 Open the Control Panel
shown at right.
2 In the
Network
Configuration
3 In the IP Address
4 Enter an IP address and subnet mask for the PC, then click
5 Restart the PC.
18
PC T
O
to initially access the modem. Enter an IP address for PC NIC
window and double-click on the
dialog (shown below), double-click
tab (or highlight
TCP/IP
tab, select Specify an IP address.
C
ONFIGURE THE
"Using the RS-232 Management Port" on page
Network
under the
TCP/IP
then click ).
Properties
M
ODEM
®
95. If you
icon
.
OK
Megabit Modem 400F User Manual
57.