ADC 400F User Manual page 51

Ž
For Routing
of RIP for intergateway transmissions. See "Routing" on page 66 for more
information on RIP. RIP is a dynamic routing protocol.

Enter the
LAN port.

Enter the
access other LAN segments or IP addresses not in its routing table.
‘
Select
DHCP Enable
assign IP addresses to devices on the LAN. If you select DHCP, ensure that all
devices on the LAN have the TCP/IP stack set to
(see "Setting Up the PC to Request an IP Address" on page
mode)
’
The modem automatically enters the start IP address for the first device on the LAN
as one address higher than the Ethernet port on the modem with DHCP enabled.
You cannot edit this field.
Enter an IP address for a device that will provide
human-readable machine names into IP addresses.
“
Enter an IP address for a device that will provide
human-readable machine names into IP addresses (optional).
The modem automatically enter the
IP address as the Ethernet 10/100BASE-T port of the modem. You cannot edit
this field.
”
Click Static MAC Table
The modem will learn up to 1024 MAC addresses and accept up to 32 MAC static
entries. Go to
configure these parameters.
•
Click Static Route Table
modem to recognize. The modem can accept up to 32 static route entries. Go to
"Defining Static Route Entries" on page 45
5 Click Submit
6 After entering a LAN IP address and subnet mask (or changing the IP address and subnet
mask), effect the configuration completing the procedures for
on page 24.
Megabit Modem 400F User Manual
mode, select the direction you want RIP activated and the version
IP Address and IP Net Mask
Default gateway IP address
to enable the modem to act as a DHCP server to automatically
to get a dialog to set up static MAC addresses for the modem.
"Defining or Modifying Static MAC Entries" on page 44
to get a dialog to set up static Routing IP addresses for the
to accept the LAN configuration.
for the modem's Ethernet 10/100BASE-T
and Default gateway Net Mask
obtain an IP address automatically
Primary DNS
Secondary DNS
IP address which is the same
Gateway
to configure these parameters.
"Saving the Configuration"
Chapter 6: Configuring Sessions
for the modem to
59). (Only in routing
. DNS translates
. DNS translates
to
43